Gauge programming button for programming any gauge that does not have a button on the front of gauge for programming. Works with all gauges that have a 3.5mm jack port on the back of gauge for programming the gauge instead of the button on the front of...
Wire harness (2-Wire) for all Performance and Classic line temperature gauges.
Wiring Harness Cable (3-Wire) for the following Performance and Classic line gauges: Boost Gauges Vacuum Gauges Pressure Gauges
Use this 3-foot extension cable to extend power cable for maximum flexibility.
Wire harness (2-wire) for the following gauge types: Speedometers (Performance and Classic Lines) Fuel Level gauges (Performance and Classic Lines)
Connect up to 8 gauges along this daisy-chain power cable. Compatible with all gauge lines. Included with all orders of 3+ gauges.
In-line Fuse - Use in line with up to 10 Speedhut gauges. 20 AWG Wire 3A Fuse Water Tight Includes 2 butt splice connectors Directions: Cut the wire in half Strip both ends Use Butt Splicers for the connections
Wire harness for: All Performance and Classic line tachometers Voltage Gauges (Voltmeter) Air-fuel Gauges (narrow and wideband)
A single power cable link
Wire harness for the Freedom CAN-BUS gauges. This harness comes with the OBDII connector. Specify length below when ordering. Special lengths available upon request. NOTE: Speedhut Freedom CAN-BUS gauges (individual or daisy chained) will not function...
LYNX Splitter Polaris Module for 5 wire Diagnostic plug allows for three Lynx Gauges for select Polaris models to be connected to one diagnostic plug. Or use two splitters to connect a maximum of five gauges to one diagnostic plug.
Mechanical Drive Cable used to connect a Speedhut SPEEDBOX to GM/Ford/Chrysler mechanical speedometers. Connector Style: Thread on